Home Email: info@philbingroup.com
Phone: 1-800-869-7301

About UsPhilbin ManufacturingPhilbin Rebuilt ProductsCatalogIndustry InformationHomeFlathead Doctor


Flatheads and Magnetos


Small D.C. Motor Repair

Special Services

Specialty Items

Specials from Philbin Rebuilt Products






Philbin Rebuilt ProductsRebuilt Products Specials


The PerTronix Ignitor Kit is a precisely engineered solid-state breakerless ignition system consisting of permanently mounted magnets for each cylinder.

Spinning with the rotor these magnets trigger an electronic chip, (Hall Cell) which is embedded in the switching module. The entire Ignitor system is immune to dirt, oil, heat, and moisture. Firing down to zero RPMs, it switches twice the energy of conventional systems. Installation is fast and simple.

The Ignitor requires no "black boxes" or complicated wiring, and can be installed in the time required to change a set of points.

The Flame-thrower, High Performance Coil is the perfect coil to go with the PerTronixs Ignitor breakerless ignition.

The new 40,000-volt Flame-thrower can benefit virtually any distributor type induction system. For one thing, the higher voltage allows larger spark plug gaps for added power, smoother response and better fuels economy. Choose from chrome or OEM black.

These coils are oil filled for better cooling and voltage insulation; or get the epoxy version of the Flame-thrower when extreme vibration is a factor.

Use the Flame-thrower High Performance Plug Wires every time you want quality ignition products.

Check out these state-of-the-art features:

  • Two current paths 1) Spiral wound stainless steel alloy. 2) Carbon impregnated fiberglass center core.
  • Low 500 OHM per foot resistance.
  • Silicone jackets to resist high temperatures, moisture, oil and chemicals.
  • EPDM rubber inner insulation for superior heat resistance and prevention of arcing and voltage leaks.
  • Fiberglass reinforcing braid for added strength and flexibility
  • Available in red, blue or black and three different boot angles (90, 115, and 180 degrees)
  • And best of all a lifetime warranty.

About Us | Philbin Manufacturing | Philbin Rebuilt Products| Flathead Doctor
Catalog | Industry Information | Home

The Philbin Group
28 N. Russell Street • Portland, OR 97227-1619
(503) 287-1718 or 1-800-869-7301
e-mail: info@philbingroup.com

Copyright © 2008 The Philbin Group, Inc. All Rights Reserved.
Website Design